Formulated with Biolux® Technology for controlled optimised biocide release. Micron® Extra does not contain organotin biocides and complies with the IMO Antifoulings Systems Convention (AFS/CONF/26) – Lloyds Register certificate number MNDE/2002/1216
PRODUCT DESCRIPTION
Micron Extra is a high strength polishing antifouling that provides 2 seasons protection from just one application. (3-4 coats). Formulated with Biolux™ Technology for controlled optimised biocide release, Micron Extra delivers extra protection even in difficult fouling conditions.
* Premium performance - extra strength formula
* Haul and relaunch without repainting
* Polishing System - avoids paint build up
Can be applied up to 12 months before launch.
PRODUCT INFORMATION
Colour YBA904-Dover White, YBA920-Blue, YBA924-Green, YBA929-Navy, YBA944-Red, YBA964-Grey, YBA994-Black
Finish Matt
Specific Gravity 1.9
Volume Solids 60% average
Typical Shelf Life 2 yrs
VOC (As Supplied) 349.5 g/lt
Unit Size 750 ml
DRYING/OVERCOATING INFORMATION
Drying
5°C 15°C 23°C 35°C
Touch Dry [ISO] 1hrs 45mins 30mins 20mins
Immersion 24hrs 12hrs 8hrs 6hrs
Note:Max. Immersion Times are as follows: 5-35°C - 12 months
Overcoating
Substrate Temperature
5°C 15°C 23°C 35°C
Overcoated By Min Max Min Max Min Max Min Max
Micron Extra 16hrs ext 10hrs ext 6hrs ext 4hrs ext
APPLICATION AND USE
Preparation PREVIOUSLY ANTIFOULED SURFACE:
In Good Condition: Rinse with fresh water and allow to dry. If old antifouling is incompatible or unknown, seal with Primocon.
In Poor Condition: Use Interstrip to remove all traces of antifouling.
PRIMING: All preparation for bare substrates is covered on the appropriate primer datasheet.
BARE GRP: Gelshield 200 for osmosis protection, or Primocon.
STEEL/IRON: Prime with Interprotect or Primocon.
LEAD: Etch Primer followed by Interprotect or Primocon.
WOOD: Preserve, if required, with Intertox. Prime with Interprotect or Primocon.
Method Apply 2 coats per season on the hull. 3 coats are required on the leading and trailing edges, waterline, rudder and keel. This is important for best performance. If 2 seasons protection is required, apply 3 coats on the hull and 4 coats on the leading and trailing edges, waterline, rudder and keel. The more you apply, the longer the antifouling protection. The boat can be left out of the water after application of the antifouling for up to 12 months before launching.
Coverage (Theoretical) - 10.00 (m²/lt) by brush; 3.0 m²/lt spray.
THIS PRODUCT CANNOT BE SHIPPED VIA AIRFREIGHT AND IS THEREFORE ONLY AVAILABLE TO PURCHASE IN THE UK, IRELAND AND EUROPE.
COLOUR CHARTS ARE SUPPLIED AS A GUIDE ONLY AND MUST NOT BE RELIED UPON DUE TO THE OBVIOUS DIFFERENCES IN HOW EACH INDIVIDUAL COMPUTER/MONITOR PORTRAYS THEM.